Slow start and RPM limit not working

[cladden]

Even with a 52V (14s) battery and QS273 motor, this thing wants to do wheelies off the line. I'm trying to use the slow start to prevent wheelies.

I have the throttle wired through the bluetooth module. When I enable the slow start and set the value all the way up (to 10 seconds), nothing different happens. What am I missing?

[cladden]

More information:

I can’t get the RPM level 1,2,3 settings to limit RPM.

I set the RPM % all the way down to 1% for all 3 levels. Then, bridged the normally open underspeed wire with other unlabeled wire in the connector. I tried bridging the overspeed wire to the unlabeled wire too. Nothing different happens. Is there a visual indication of the current “level” in the app?

Cruise control does work.

[PVadmin]

It's recommended leave all RPM levels at 100% and program Torque Levels in the app instead to limit the power and then use a three position switch to easily select the power level you need on the go. The torque level settings will not show the speed difference on a raised wheel but will be felt under load. Some recommends settings: Torque level 1 - 15%, Torque level 2 - 50%, Torque level 3 - 100%.

With levels 1,2 selected in this example, the wheelies will be much mitigated.